The product you were looking for no longer exists! Here are products you may be interested in from the same category.
Black woven insulation over temperature wire, with clip.
Includes:
Temperature Wire Terminal End
Temperature Wire End
Temperature Wire InsulationINSULATOR SENDING SENSOR WIRING…
Replacement SensorFits All Engines Except ZR1 (LT5)Located In Cylinder HeadOperates Temperature Gauge In Dash…
Installation may be simplified by using a UH-7 terminal end, or cutting wire at harness and reconnecting.
If old wire is damaged from engine heat, it can also be replaced with the insulation in this manner.
…
TPS/IAC sensors to complete your throttle body assembly.
…
The variable resistor kit should correct almost any gauge that reads higher than the actual engine temperature. Install the resistor in line with your temp wire and set it to your engine temperature for gauge accuracy. It has a resistance…
The Engine Coolant Temperature Sender monitors the engine temperature. The engine temperature signal is used by the engine control module to adjust the air/fuel mixture and ignition timing. Male oval connector
81-84 Located in Front…
If Replacement Pigtail is Needed Use Part #1P1006…
(includes new asphalt loom, wire, terminal, & connector)
…
This stock replacement outside air temperature sensor is manufacturedby GM or by one of its authorized suppliers for use as a factoryreplacement part. You will find the fit, finish and function meets allGM specifications. Using stock…
Replacement Sensor
Black Wire Connector End
Solid Probe
1985-91 Located Under Plenum
1992-96 Located In Water Pump
For Computer Input
This Corvette replacement engine coolant temperature sensor has been…
Replacement Sensor
Gray Wire Connector End
Open Probe
This Corvette replacement intake plenum manifold air temperature sensor has been manufactured to meet or exceed factory specifications and performance. You will…
All Engine Coolant Temperature Sensor Connector are constructed of high-quality materials for long-lasting durability.
…
2 Wire repair pigtail
Replaces your factory pigtail that has been damaged by aging and heat. Pigtail connectors allow for more efficient, less costly wiring harness repairs. Wires are color coded and include plugs for easy…
This Corvette replacement air intake temperature sensor has been manufactured to meet or exceed factory specifications and performance. You will find the fit and function will work perfectly for your Corvette
Replacement…
Replacement Sensor Located In Right Cylinder Head For Temperature Gauge This Corvette replacement engine coolant temperature sensor has been manufactured to meet or exceed factory specifications and performance. You will find the fit…